I’m having problems with my filament when im printing the trigger housing/part of the frame that would cover your trigger finger. The flat part of the trigger guard that bridges across I get some squiggly filament build up for a few passes but I’m able to make a few layers but I want to find out if anyone else knows what I’m talking about. Might not have explained that very well so let me no.
Trigger finger/guard part of the frame issue when printing
- Thread starter Pagss
- Start date
Photos always help. Someone here will know how to help you. 3D printing is not my thing (yet).
Thanks for joining the forum and participating by posting! When you get a chance, please write up a quick “introduction” (or RE-introduction if you were a former MGB forum member) of yourself over in the Introduce Yourself! section. Tell us about yourself, your building experience, and how you found the forum.
Jump into other threads, too! Come on in... the water's fine!
Thanks for joining the forum and participating by posting! When you get a chance, please write up a quick “introduction” (or RE-introduction if you were a former MGB forum member) of yourself over in the Introduce Yourself! section. Tell us about yourself, your building experience, and how you found the forum.
Jump into other threads, too! Come on in... the water's fine!
- Joined
- Dec 31, 2024
- Messages
- 551
- Reaction score
- 529
- Points
- 108
From what it sounds like you are explaining, either the inside bottom of the trigger guard where your finger rubs on it when pulling the trigger if you printed rails down, or the outside bottom, where it is mostly asthetic, if you are printing rails up. The problem may be in your support settings. Either too close, or too far, and too few layers.
But as Racer said, pictures would help.
But as Racer said, pictures would help.
Last edited: