Anderson Mfg. - Kiger 9c

You may want to try a different housing maybe an aftermarket one or you could bend the sear down so it will release. Just be careful not to torque the bar and bend it elsewhere. You could also run a GPT or Timney and it would work. Glock housings are the best but the frame holes for the housing may be causing the housing to ride higher than it should.
 
How about a good side view. I can't tell from this one picture but it almost looks like the slide is too far forward. If you pull the trigger all the way back and start pulling the slide rearwards, does it let the sear come down off of the striker?
 
Do you have the slide lock on correctly? The notched part should face the rear.
 
Ok, I changed housings and connectors and it works as it should. Never had this problem before, I guess I’ve been lucky
 
Yeah, sometimes that’s all it takes. Pretty sure I could make a Glock out of a potato and it would work.
 

Share this page

Back
Top